Krix Epix User Manual

Owner’s ManualEpix - Back Box

installation8.8.10.10.10.10.10.10.installing plasterboard8. Cut plasterboard to size and slide under metal edging. 9. Attach plasterboard to stud wor

Frequency Range 40Hz - 40kHz in room responsePower Handling Maximum 200 watts RMS amplifier power into 4ohmsSensitivity 90dB for 2.83 volts at 1 metre

krix.comKrix Loudspeakers Pty Ltd14 Chapman RoadHackham SA 5163AustraliaT 61 8 8384 3433F 61 8 8384 [email protected] Rev #10003

Congratulations on choosing Krixsetup in briefThe following setup procedure will help you achieve the best performance from your inwall speaker:1. unp

before you beginNew ConstructionThe Krix Epix inwall speakers have been developed to suit 45x90mm or 35x90mm timber stud construction. The speakers mu

4positioningfront left and right speakersAs a guide, the placement of left and right speakers used for two-channel stereo should form an equilateral t

450mm centers refer to local building code450mm centersEnsure a clear path is maintained for cable insertion 450mm centersapproximately seated ear hei

450mm centers refer to local building code450mm centersEnsure a clear path is maintained for cable insertion approximately seated ear heightA vertical

2.2.3.3.11!11!7installationinstall enclosure using temporary braces1. The installation braces are supplied factory fitted for 10mm plaster boar

installation85.5.4.4.4.4.install timber Phillips screws4. Install the coated Phillips drive screws using an extended Phillips bit. 8 x coated Philli

installation9routing speaker cable6. Route speaker cable through studwork to speaker. 7. Securely screw cable into to binding posts. Take care to ass